Tandberg reel to reels

Home › Forums › High End Audio › Vintage Electronics
jack d ii -- Tue, 01/27/2009 - 18:31

 I have two.  One has been used maybe 10 hours or less.  The other has a rubber drive wheel that is going away.  The first one has been in its original box for 30 years and wont start although juice is getting to it.  I would like to locate a schematic with which I might get someone to solve the sure simple problem of getting #2 to start.  The rubber wheel should be around someplace but where?  Any help would be much appreciated.

‹ Suggestions for Good Online Forum for Reel to Reel Tape Deck Advice? audio research D79b ›

laminarflow (not verified) -- Wed, 01/28/2009 - 09:47

If number one is a 10XD, I can help you. I have the service manual, which contains schematics.

jack d ii -- Thu, 01/29/2009 - 15:09

 Both are 3641, three speed, quarter inch models.  Sorry for not including that info.  They are generally described as 3600 models.  Thanks anyway.

 Jack D II

GJM (not verified) -- Thu, 02/04/2010 - 11:07

  I HAVE A PIONEER   RT-909  THIS IS ONE SWEET DECK THE SOUND IS OUT OF THIS WORLD BEST SOUND I EVER HEARD I AM A VINYL NUT THE 909 SOUNDS BETTER THEN ANY VINYL I EVER HEARD

jack d ii -- Thu, 02/04/2010 - 20:06

I have a few 1800 ft. tapes I recorded at 7.5ips and they sound at least as good as my Nottingham 294 with Dynavector 17 D3 cartridge.

 Jack D II

just joe (not verified) -- Fri, 02/12/2010 - 20:16

I just picked up a Tandbery series 10XD for free.  I cleaned it and it seems to be working fine.  Can anyone tell me the correct way to load a tape on to it ???  Thank you.  joe

bobboyer -- Fri, 03/19/2010 - 07:52

You might check with Soundsmith (Soundsmith.com?). I think Peter rebuilds some Tandberg products and might have parts or know of a source.

All content, design, and layout are Copyright © 1999 - 2011 NextScreen. All Rights Reserved.
Reproduction in whole or part in any form or medium without specific written permission is prohibited.