Pairing pre amp, amp and reciever with speakers

Home › Forums › Home Theater › Receivers, Amps and Processors for Home Theater
biji_ta@yahoo.com -- Fri, 07/20/2012 - 01:16

 I was planning to pair the following for my home theatre system:
PRE AMP
ONKYO PR-SC5508 : THX Ultra2 Plus Certified 9.2-Channel Network A/V Preamplifier
 
 
AMP
ONKYO PA-MC5500 : THX Ultra2 9-Channel Power Amplifier
RECEIVER
ONKYO TX-NR1010 : 7.2-Ch THX Certified Network A/V Receiver
SPEAKERS
Triton Cinema Three - consists of two triton three towers with build in subwoofers, supersat 50C center channel and one pair of super sat 3 for surronds/speakers
Would anybody have any feedback on the abover setup?
 
 
 

‹ Digital -> analog sound for wireless headphones AV Processor Recommendations Requested - Replacing Lexicon MC-12B ›

biji_ta@yahoo.com -- Fri, 07/20/2012 - 01:19

Would appreciate any feedback on the above configuration.

Tonkatoy -- Wed, 08/15/2012 - 08:43

Hello, normally you would just need one 5.1 or 7.1 channel AV receiver to power s surround sound system, is there any reason you are also including a separate processor and multi channel power amp? The Onkyo TX-NR1010 should have plenty of power, connectivity, networking and video upscaling for most users needs.

All content, design, and layout are Copyright © 1999 - 2011 NextScreen. All Rights Reserved.
Reproduction in whole or part in any form or medium without specific written permission is prohibited.